5
Assembly
1
Preparing media shelf, base and side panels assembly
NOTE: Do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back and fully tighten all bolts.
This will make the assembly easier.
□
Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a carpeted
floor or the empty carton to avoid any scratches.
□
Securely screw the cam bolts (FF) into the designated small holes on the media shelf (O), bottom panel (P) and side
panels (Q and T) using a Phillips screwdriver. DO NOT overtighten the cam bolts.
2
Gluing wood dowels
□
Glue the long wood dowels (CC) into the designated holes on the media shelf (O), side panels (Q and T), lower
partition panels (R and S) and middle crossbar (X) as shown.
NOTE:
Refer to the dowel assembling guide drawings in this step for further clarification on how to properly glue in the wooden
dowels. Apply this method whenever instructed to install wood dowels. It is very important to use a small amount of glue on both
ends of dowels and wipe off the excess glue immediately with a damp cloth.
CC
CC
O
P
FF
Q
T
CC
CC
CC
CC
CC
CC
O
Q
T
R
S
X
