Leveling Information
It is recommended that the unit is level.
1. Use a level to check the
levelness of the unit from
front to back and from side
to side. Level should be
placed along top edge and
side edge as shown
2. If the unit is not level,
adjust the feet on the
corners of the unit as
necessary.
3. Check the levelness after
each adjustment and repeat
the previous steps until the unit is level.
INSTALLATION TIP
If the room floor is higher than the floor in the
cut-out opening, adjust the rear feet to achieve a
total unit rear height of 1/8" less than the opening’s
rear height. Shorten the unit height in the front by
adjusting the front feet. This allows the unit to be
gently tipped into the opening. Readjust the front
feet to level the unit after it is correctly positioned in
the opening.
Turn Foot To Adjust Height
Installation
1. Plug in the power cord.
2. Gently push the unit into position. Be careful not
to entangle the electrical cord.
3. Re-check the leveling, from front to back and
side to side. Make any necessary adjustments. The
unit’s top surface should be approximately 1/8"
below the countertop.
4. Remove the tape from the glass shelves and
wipe out the inside of the unit with a clean,
water-dampened cloth.
Relocating the Shelves
Both the glass shelves in the refrigerator and the
inner door shelves can be moved to accommodate
your bottles, cans and containers.
Glass Shelves
Open door fully, grasp shelf firmly, lift front edge
slightly, and pull straight out.
Choose new location and slide shelf onto the
appropriate rib.
Door Shelves
First pull shelf up at a 45° angle, then straight out.
Choose new location and line up on bosses. First
push straight in, then down at a 45° angle.
Installation Troubleshooting
Q: Problem
The door remains open unless it is pushed closed.
A: Solution
Re-check leveling from front to back of the unit
and readjust if necessary. Make sure the pivot
plate is installed correctly.
May 2011
Page 9
SCR33
User's Manual
Turn Foot
To Adjust Height