COMPONENT DESCRIPTION
Control Box: Contains the electrical controls that
operate the machine.
High Pressure Cut Out Switch: A manual reset
switch sensing the high side refrigeration pressure.
It is set to shut the machine off, and illuminate the
reset switch light if the discharge pressure should
ever exceed 450 psig.
Evaporator: A vertical stainless steel tube,
refrigerated, and water filled. In it there is a
stainless steel auger.
Reservoir: Float operated, it maintains the water
level in the evaporator at a constant level, it also
contains the water level sensor.
Water Level Sensor: Senses if there is water in
the reservoir to make ice out
of. Will shut the machine off it
there is none.
Ice Level Sensor: An
electronic "eye", it senses the
presence of ice in the bottom of
the ice discharge chute.
Operates to turn the ice
machine on and off
automatically as the level of ice
in the bin changes.
Drain Tube: When uncapped
and lowered, drains the
evaporator.
Condenser: Air or water
cooled, where the heat
removed in ice making is
discharged.
Ice Storage Bin Assembly: A
plastic lined, insulated cylinder
that receives, stores and
dispenses the ice. Fresh ice
enters at the top, and when the
bin is full enough the ice will be
between the ice level sensors,
and the icemaking will stop. Ice
is dispensed through a chute at
the bottom front when the
agitator assembly sweeps the
ice over the chute.
Glass Filler Lever: Pushing in
on this lever causes the ice
dispensing cycle to occur.
Portion Control Knob:
Turning this knob adjusts the
length of time of dispense.
Low Pressure Cut Out Switch: A manual reset
control that shuts off the ice machine when the low
side pressure drops below a preset point, 0-4 psig.
ICE LEVEL SENSORS
WATER LEVEL
SENSOR
RESERVOIR
EVAPORATOR
ICE STORAGE BIN
GLASS FILLER LEVER
PORTION
CONTROL
LOW PRESSURE
CUT OUT
CONDENSER
DRAIN TUBE
CONTROL
BOX
HIGH PRESSURE
CUT OUT
ND650
March, 1989
Page 11
