FOR THE INSTALLER
This ice dispenser has been specifically designed
to provide protection against personal injury and
eliminates contamination of ice. To ensure
continued protection and sanitation, observe the
following:
·
ALWAYS: disconnect power to the dispenser
before servicing or cleaning.
·
NEVER: place hands inside of hopper or gate
area without disconnecting power to the
dispenser.
·
Agitator rotation occurs automatically when
dispenser is energized!
·
ALWAYS: be sure the removable lid is properly
installed to prevent unauthorized access to the
hopper interior and possible contamination of
the ice.
·
ALWAYS: be sure the upper and lower front
panels are securely fastened.
·
ALWAYS: keep area around the dispenser
clean of ice cubes.
·
CAUTION:
Dispenser cannot be used with
crushed or flaked ice.
Use of bagged ice, which has frozen into large
chunks, can void warranty.
The dispenser agitator is not designed to be an ice
crusher. Use of large chunks of ice which “jam up”
inside the hopper will cause failure of the agitator
motor and damage to the hopper. If bagged ice is
used, it must be carefully and completely broken
into small, cube-sized pieces before filling into the
dispenser hopper.
DESCRIPTION
Designed to be manually filled with ice from any
remote ice-making source, these dispensers will
dispense cubes (up to 1-1/4” in size), cubelets and
hard-chipped or cracked ice.
IMPORTANT: For dispensing compressed or
extruded style ice, an Ice Diverter Kit must be
installed on the dispensers (see ICE DIVERTER
KIT (KNUGDIV) in INSTALLATION
INSTRUCTIONS section of this manual. The Ice
Diverter Kit is part of the KBT46 adapter.
ID150, ID200, ID250
May 2002
Page 3
