Accessing 12V Power
VEHICLE DISASSEMBLY
Cont'd
4. Remove mat from the center
console's back panel, then remove
(4)
screws exposed.
5. Use a panel removal tool to
remove the plastic panel under the
armrest lid.
TESTING QI MODULE (MQUSM)
Testing Connection:
Before proceeding to the preparation/installation please test the modules
functionality by connecting the provided vehicle specific !-harness (diagram on right). Once the module is
connected, place the Qi-enabled device on the module and refer to the LED Status chart below for specifics.
For technical assistance with the installation please call or visit us on the web at:
1-800-363-4490 x1 I www.scosche.com/contact
Female Connector to
To QI Module
NOTE: The module can also
be tested by connecting it to a
USB to type-c connection power
source not included .
�-£)-�
Male Connector to
Back of 12V Socket
FOREIGN OBJECT DETECTION: Please follow the MAGICPLATE
™
mounting instruction on pages
2 or 3 for best charging results. Note that blocking the charging coil with anything metallic object
may cause the module to not work as designed.
BATTERY VOLTAGE REQUIREMENTS: The MQUSM (Qi Module) is designed to operate at
voltages between 13.2-14.7. If your vehicle does not supply sufficient voltage with the ignition OFF,
you may need turn the ignition to the ON position in order to operate the MQUSM. For questions
about this product please contact our Scosche tech support team at:
(800) 363-4490
ext.
1
or
5
