2
FACTORY WIRING CODES
For Factory Wiring Codes go to:
www.scosche-cars.com
This premium installation kit is for 1992-UP General Motors vehicles with oversize radio/M3000. Included are all the
parts you need to mount your car stereo.cassette or CD player into your vehicle's dash. Refer to the individual instruction
in this manual to remove your vehicle's factory radio and assemble this kit.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP
PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHM METER OVER A TEST
LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE
VEHICLE'S COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID ALL FACTORY AIR BAG WIRING - AIR
BAGS CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH.
NOTES:
•
See your vehicle's instructions for any special tools your installation might require.
•
Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting instructions.
INTRODUCTION / PRELIMINARY
GM1583 POCKET PREPARATION
1. Cut along dotted line to remove middle
screw mounting tab. (Illustration "A")
ILLUSTRATION "A"
2. Attach pocket to kit for added pocket
strength, attach screw as shown in
illustration (Illustration "B")
FRONT VIEW OF POCKET
ILLUSTRATION "B"
BOTTOM
VIEW OF KIT
FRONT
OF KIT
1997-UP Buick Century
RADIO REMOVAL:
1. Extract (1) screw from bottom lower dash panel at right of glove box.
2. Open glove box and pop out small lower dash panel along the right side.
3. Carefully pop out fuse box cover at right side of dash and extract (1) screw from the
dash bezel at the right of the air vent.
4. Extract (2) screws at the bottom of the lower ashtray/lighter dash section pop out and remove.
5. Extract (1) screw from the right driver’s side lower dash panel and one panel popper from the left side.
6. Carefully pop out the driver’s side lower dash panel and remove.
7. Put the vehicle into first or low gear, and tilt the steering column adjustment all the way down and pull outward on
the complete dash panel to unsnap, unplug, and remove panel.
8. Extract (3) 7 MM screws holding radio, unplug connector, antenna cable and remove radio.
Содержание GM1583
Страница 8: ...8...
