15
To tilt the fence, loosen the tilt lock handle (C), angle
the fence as required (D), and re-lock the handle.
C
D
Setting the 90° fence stop
Adjust the fence so that it is at 90° to the table using
a square, and flip the 90° stop into position (E). Then,
loosen the jam nut (F) and adjust the stop bolt (G) until
it is in contact with the flip stop. Retighten the jam nut
and confirm the fence is square to the table.
Setting the 45° fence stops
Adjust the fence so that it is at 45° outwards from the
table using a square, and loosen the jam nut (H) on the
45° stop bolt (I). Adjust the stop bolt until it is in contact
with the fence, retighten the jam nut and confirm the
fence is 45° to the table.
E
F
G
I
H
Adjust the fence so that it is at 45° towards the table
using a square. Adjust the nyloc nut (J) until it is in
contact with the stop (K), and confirm the fence is 45°
to the table.
K
J
Operating Instructions
Switch Lockout Pin
The On/Off switch is equipped with a lockout safety
pin (A). When the pin is installed through the green
ON button, the jointer cannot be started. Leave the pin
installed whenever the jointer is not in use.
Starting the Jointer
Lift the red stop paddle and remove the lock-out pin.
Lower the stop paddle and push the green ON button.
Stopping the Jointer
Push on the red STOP paddle and wait for the cutter to
come to a complete stop. Always re-install the lockout
pin when you are done using the jointer.
A
