Sensor Memory Display
1.
When the system is disarmed the turn signals will flash to indicate if there has
been an alarm trigger. The lights will flash once to indicate that the system has
been disarmed, additional flashes indicate that the following trigger has
occurred:
1 flash then 1 additional flash = Shock Trigger
1 flash then 2 additional flashes = Tilt Trigger
1 flash then 3 additional flashes = Perimeter Sensor Trigger
1 flash then 5 additional flashes = Ignition Trigger
RCS (Range Confirmation Signal)
1.
If the Transceiver is within range of the MCM the LCD displays icon
2.
If the Transceiver does not receive the RCS signal the icon will not appear.
Transceiver Battery Status
1.
The LCD will display 3 different
icons to show the Transceivers battery
status.
Motorcycle Battery Status
1.
When the voltage on the motorcycle battery drops below 11.2 volts The LCD
displays icon.
Battery Safeguard with “Sleep Mode”
1. If the alarm is armed for more than 30 days, it will automatically disable the
MCM’s receiver. In this mode the Transceiver will no longer be able to operate
the system. Note: In this mode, the system is still armed and protecting the bike.
2. To disarm, trigger the alarm, and press button #2.
NOTE: If the optional perimeter sensor is being used and the alarm is armed for more than 10 days
the system will automatically disable the perimeter sensor.
Locking the Transceiver’s buttons
1.
To “lock”, press button #4 for 2 sec. The Transceiver will beep and buttons will
lock
2.
To “unlock”, press button #4 for 2 sec. The Transceiver will beep and buttons will
unlock.
Turning the Transceiver On/Off
1.
To turn “off”, press button #4 for 4 seconds. The Transceiver will beep two times
to indicate that the unit has been turned “off”.
2.
To turn “on”, press button #4 for 4 seconds. The Transceiver will beep two times
to indicate that the unit is turned back “on”.
Note: When the Transceiver is in the “Off” mode the clock will still be displayed
7
Fuse
To Battery (+)
Accessory
HAR-1 Connector
GEN-1
Black – To Ground (-)
MCM Grey – To Turn Signal
Grey – To Turn Signal
Orange – To Tail Light
Note: Connect the (HAR-1) harness to the MCM only after installation is completed.
If the battery is to be removed, disconnect this connector first. Reconnect only after battery
terminals are reconnected.
Using the T-tap Connectors
1) Place female T-tap connector over wire to be tapped, close and squeeze until it snaps
close. 2) Now slip male T-tap connector over hinged end of the female connector to
make a connection.
Motorcycle Wire
1)
Female T-tap
2)
Female T-tap
Male T-tap
Motorcycle
Wire
Wire from (GEN-1)
4