3. Press button 4 repeatedly to
scroll though the programmable
icons
NOTE:
Press button 3 to
ng
exit without
changing the
setting or savi
4. Press button 1 to
begin
select icon and to
programming
1. Press button 4 twice to
P
enter programming
mode
1. Press Button 2
to scroll
between the
alert options
Alert options include: alert
audible, vibrate and audible
off, vibrate,
Note: Although the system will work in any position or mounting bangle, try to avoid placing the
MCM with the bell of the siren facing toward either side of the bike. This may reduce sensitivity
rogramming Instructions
ing mode:
es not have to
) Prog
m
MCM- To program the MCM the system must be installed, with in
er (impact/shock sensor).
nterin Pr
ogramming mode:
electing Transceiver Alert Type (Audible/Silent Vibrate)
ss button #1 to
There are two types of programm
1) Programming the Transceiver- To program
be installed or be within range. The program
the transceiver the MCM do
mable modes for the Transceiver are:
•
Transceiver Alert Type (Audible/Silent Vibrate).
•
Alarm Clock.
•
Clock.
2
ram ing the
range, and in the disarmed mode. The programmable modes for the MCM are:
•
Auto/Manual Arming.
•
Siren Tones and Siren Duration.
•
Adjusting ADL202 Acceleromet
E
g ogramming Mode
Follow the steps below to enter the pr
S
1.
Enter programming mode. The icon will begin to flash, pre
select. The LCD will display the current settings. To program follow these steps:
9
Components List
MCM (Main Control Module)
Remote Transceiver
Accessory Harness
Generic Instillation Kit (GEN-1)
Main Harness (HAR-1)
Planning the Installation
It is very important that before starting the installation of the security system, you carefully
read the installation instructions and spend time planning the installation. By planning
ahead you will be able to select the best approach in placing, securing and wiring the
system to your specific motorcycle. Although the installation is not difficult, there are a
number of steps that must be taken for the system to operate properly. We suggest the
following steps:
1.
Check that your motorcycle battery is fully charged and that all electrical circuits are
in good working condition.
2.
Check the layout and construction of the motorcycle to decide what space is
available to place components.
3. Verify that no moving parts interfere with the components or their wires.
4. Do not route wires near sharp edges, which could cause a short.
5. Do not mount components near extreme heat areas such as exhaust pipes etc.
6. Allow at least an inch or two of slack at all connection points to reduce the chance
that a connection will break apart due to vibration.
7 Do not use a drill. Mount the components with the provided Velcro and cable ties.
Mounting the Components
Select a suitable location under the seat or in a side cover. Mount the MCM using Velcro
or cable ties. Make sure that it is not exposed or easily reached.
2
2. Available programmable
options will be displayed.
The selected Icon will flash
2. Press button
4 to save and
exit
Note. At any time during programming press button # 3 to exit without saving and return to the
main screen