Operating Instructions
Arming (audible)
Press the A button, siren chirps 3 times and the turn signal lights flash 1 time. System is
armed.
Note: Once an alarm trigger has occurred and the siren duration is completed the system will remain
armed and accept any additional triggers.
Disarm (audible)
Press the A button, siren chirps 1 time and the turn signal lights flash. System is disarmed.
Arming (silent)
Press the B button, turn signal lights flash 1 time. System is armed.
Disarm (silent)
Press the B button, turn signal lights flash. System is disarmed.
Arming Without Perimeter Sensor (optional)
Note: If the optional perimeter sensor is being used and the alarm is armed for more than 10 days the
system will automatically disable the perimeter sensor
Press the C button, siren chirps 4 times and turn signal lights flash 1 time. System is armed
but the Perimeter Sensor is disabled.
Arming in Transport Mode
Press the A button and the B button at the same time, siren chirps 5 times and the turn
signal lights flash 1 time. System is armed but the Impact, Tilt and Perimeter Sensor
(optional) are disabled.
Panic/ Stop Trigger
With the system armed press the C button for a panic feature. Siren will sound and lights
will flash. Pressing the C button during an alarm trigger stops the alarm cycle but the
system remains armed.
Battery Safeguard with “sleep mode”
1. If the alarm is armed for more than 30 days, the system will automatically disable the
MCM’s receiver. In this mode the remote will no longer be able to operate the system but
the system is still armed and protecting the bike.
2. To disarm, trigger the alarm, and press the A button.
Alarm Triggers
1. If bike is bumped, the siren will sound for 5 Seconds and the turn signal lights will flash.
2. If the bike is tilted, the siren will sound for 30 seconds and the turn signal lights will flash.
3. If the ignition switch is turned “on”, the siren will sound for 30 seconds and the turn signal
lights will flash.
5
Components List
MCM (Main Control Module)
Remote Transceiver
Accessory Harness)
Generic Instillation Kit (GEN-1
Main Harness (HAR-1)
Planning the Installation
It is very important that before starting the installation of the security system, you carefully
read the installation instructions and spend time planning the installation. By planning
ahead you will be able to select the best approach in placing, securing and wiring the
system to your specific motorcycle. Although the installation is not difficult, there are a
number of steps that must be taken for the system to operate properly. We suggest the
following steps:
1.
Check that your motorcycle battery is fully charged and that all electrical circuits are
in good working condition.
2.
Check the layout and construction of the motorcycle to decide what space is
available to place the components.
3. Verify that no moving parts interfere with the components or their wires.
4. Do not route wires near sharp edges, which could cut wires and cause a short.
5. Do not mount components near extreme heat areas such as exhaust pipes etc.
6. Allow at least an inch or two of slack at all connection points to reduce the chance
that a connection will break apart due to vibration.
7 Do not use a drill any holes. Mount the components with the provided Velcro and
cable ties.
2
