Standard Features
•
3 Channel waterproof remote transmitter
•
Ultra low power drain MCM
•
Built-in Analog Devices ADXL202 accelerometer
•
Ignition protection
•
Remote sensor control
•
Battery safeguard with “sleep mode”
•
Violation display
•
Passive arming
•
Selectable arming / disarming
•
Automatic reset
•
Silent arming/disarming
•
Flashing lights
•
Integrated 125 dB multi-tone siren
•
Transport Mode
•
Remote panic feature
•
Soft chirp arming
•
Selectable Perimeter Sensor arming
Optional Accessories
•
Perimeter sensor – A miniature multi stage microwave sensor that detects motion
in mass around the motorcycle, and uniquely protects its parts and accessories.
Detects any attempt to tamper with saddlebags, luggage or accessories.
•
Ignition disable and anti-hijack kit- Allows remote disabling of the motorcycle’s
electrical system, should someone force you off your bike. Also prevents the
engine from being started when the system is armed.
•
Factory Connector Kits–OEM style connectors that simply plug into the
motorcycle’s factory wiring harness. Connector kits are available for select
motorcycle models.
1
A button & B Button at the same time
Arm in Transport Mode
C Button
Arm without Perimeter Sensor
A Button
Arm/Disarm
B Button When Armed C Button
Silent Arm/Disarm Panic Feature
Violation Display
When the system is disarmed the turn signals will flash to indicate that there has been an
alarm trigger. The lights will flash once to indicate that the system has been disarmed and
additional flashes indicate the following trigger has occurred:
1 flash then 1 additional flash = Shock Trigger
1 flash then 2 additional flashes = Tilt Trigger
1 flash then 3 additional flashes = Perimeter Sensor Trigger
1 flash then 5 additional flashes = Ignition Trigger
Selecting Arming Modes
Turn ignition on and press the A button for 5 seconds.
-Manual arming- siren chirps 2 times, lights flash 2 times.
-Automatic arming- siren chirps 3 times, lights flash 3 times.
Adjusting G sensor Sensitivity
Turn the ignition switch to the “on” position, press and hold down the C button, while
holding down the C button turn the ignition switch off. The siren will chirp and lights flash to
correspond with the current sensitivity setting. To check sensitivity stand motorcycle to the
upright position, a short siren chirp indicates an alarm trigger. To get out off the sensitivity
adjustment mode, turn ignition back on.
-
Increase sensitivity- Press the A button 5 chirps = Level # 5 (Maximum)
-
Decrease sensitivity- Press the B button 1 chirp = Level #1 (Minimum)
6