scoole SC HT HL1 1000 W, Инструкция по эксплуатации

Страница: 8 / 44

INSTRUCTION MANUAL
8
Regularly check that the plug tightly fits the receptacle as follows: a) insert the plug into the receptacle;
b) switch the heater off in half an hour of operation and remove the plug from the receptacle; c) check by
hand whether the plug is hot. If the plug temperature exceeds 50°C, the receptacle should be replaced
by a qualified specialist to avoid damage, accidents, or fire as a result of poor electric contact.
7. Heater control
Heaters of SC HT HM1 series are equipped with a mechanical thermostat.
Heaters of SC HT HL1 series are equipped with a high-precision electronic thermostat with a LED-
display.
WARNING!
The receptacle should be designed for rated current not less than 10A, while the electric cable should
have wire section not less than 3x1.5 mm2 (for copper).
1. Two-key switch, with indication*
This switch is used for selection of the following modes of
heating power: "ECONOMY" (low power), "COMFORT"
(medium power), "EXPRESS" (high power).
2. Thermostat knob
This knob is used for setting of desired temperature in the
room.
* - Except for SC HT HM1 1000W, SC HT HM1 1000BE, and
SC HT HM1 1000G models, which have one heating power
and use one-key switch.
Operation of SC HT HM1 series convection heaters
1. Switching on
Insert the plug of the power cord to the receptacle to connect
the heater to the electric mains.
Figure 3.
1
2