SCM SC 10, Руководство пользователя

Страница: 9 / 34

8
4. STORAGE AND HANDLING
5. INSTALLATION :
(FIG.1 PAGE 23 FIG. 5 PAGE 28)
5.1 PRELIMINARY INSPECTIONS :
Store the product in a dry and dust-free place.
Avoid instability which could be caused by improper positioning of the
product.
Turn the rotating parts at regular intervals to prevent them from possible
jamming (consult the “Preliminary inspections” chapter for relative
procedure).
WARNING: BEWARE OF NOT CAUSING ANY DAMAGE TO
THE ELECTRIC CABLE WHEN HANDLING THE AERATOR (SEE PICTURE
1 PAGE 23).
ATTENTION
For a safe storage after previous installation, the product must be
thoroughly cleaned (do not ever use hydrocarbon based products for this
purpose).
The submerged aerator must be handled with care. Use suitable lifting
means in compliance with the safety provisions in merit, gripping the
product by the relative lifting points (handles, eyebolts).
(SEE PICTURE
2 PAGE 24).
Do not ever use the powering and grounding cables for handling purposes.
Do not bend the cables sharply (the minimum radius of the bend must
be more than 5 times the diameter of the cable itself).
The extreme ends of the cables must never be immersed or wetted in
any way.
• Check that the machine did not suffer damages during transport;
• Install the aerators in a position as vertical as possible. The use of the
aerator in a non-vertical position causes a more serious wear and tear
of the rotating parts.
• Do not submerge the extreme ends of the cable and do not use the
cable to lift or lower the aerator; use the special chain instead. The
disrespect of these rules may lead to water in the cable or broken wires
on the internal , causing a motor out of order.