SCION
xD
2012–
TVIP V5
CHECKLIST – these points
MUST
be checked to ensure a quality installation.
SCION SECURITY
Issue: A 10/18/11
13
Reach inside and manually unlock the front
passenger’s door to trigger an alarm.
The front passenger’s door automatically relocks.
The horn sounds repeatedly.
The headlights flash repeatedly.
The turn signal lights flash repeatedly.
The Security LED lights up.
14
Press and release the remote control’s
unlock button to stop the alarm.
The horn stops sounding.
All the lights stop flashing.
The Security LED stops flashing.
15
Press and release the remote control’s lock
button to start the system’s arming process,
then wait 30 seconds until the system is
armed.
Refer to steps 1 and 2.
16
Unlock and open one of the rear passenger
doors to trigger an alarm. (if available)
Refer to step 13.
17
Press and release the remote control’s
unlock button to stop the alarm.
Refer to Step 14
18
Repeat the above steps with the other rear
passenger door. (if available)
Refer to steps 1, 2, and 13.
Roll up all windows, remove the key and exit the vehicle.
19
Press and release the remote control’s lock
button to start the arming process.
Refer to step 1.
20
Wait 30 seconds.
After 30 seconds, the Security LED starts flashing; the
system is now armed.
Perform the following check in a temperature-controlled environment. (50°-90° F)
21
With the tip of a key, or Striker Tool pulled
all the way out (PPO only), tap the center
of the driver’s door window to trigger the
alarm.
The horn sounds repeatedly.
The headlights flash repeatedly.
The turn signal lights flash repeatedly.
The Security LED lights up.
22
Insert the key into the driver’s door key
cylinder and turn it toward the back of the
vehicle to stop the alarm.
Refer to Step 14
NOTE:
If the alarm still does not trigger during the section test, increase the GBS sensitivity to the next setting and
test again.
NOTE:
If you do not disarm the system, the alarm will last 20 seconds. It is not necessary to check the alarm duration.
Page 21 of 23 pages
