4
Copyright (C) Scintex | www.scintex.com.au | [email protected]
Instructions:
1. Fill the chemical tank with the correct mixture according to the chemical that you are using.
The tank has a 20L capacity; do not overfill according to the indicator levels on the side of the
unit.
2. Apply cap to chemical tank to prevent air leakage.
3. Ensure battery is placed in the unit and connected.
4. Place unit on back and tighten straps.
5. Toggle switch to either Low Pressure or High Pressure pumping
a. Use low pressure for herbicides, weed control and disinfectants
b. Use high pressure for wettable powders, pests and sterilisation
6. Squeeze the trigger to begin pumping the chemical
7. For a continuous spray use the clasp to hold the trigger permanently in.
After Use:
1. Once finished with the spray unit turn off the unit by moving the toggle switch to the centre
spot.
NOTE:
We recommend flushing the unit with fresh water after each use
2. Empty the chemical tank and clean out with fresh water.
3. Run the pump and hold the trigger on for 2-3 minutes running fresh water through the unit to
clean.
4. Disconnect the battery
NOTE:
If storing for a long time (2-3 ) the battery should be stored fully charged and we
recommend that you connect to the charger every 3 months to ensure its longevity.
