S
ervice Manual
Remote Control Cable/Radio
563
10. Operating the Radio Remote
Control
NOTE! In order to avoid undesired movements of
the machine, ALWAYS switch off the power sup-
ply of the transmitter (selector switch to “OFF”)
when the machine is not in use.
If the engine is not fitted with an engine ON/OFF
switch, start the engine with the “ignition key”.
Putting on the transmitter
1. Insert the spring hooks of the upper belts into the
carrying frame.
2. Place the belts over the shoulders.
3. Insert the spring hooks of the lower belts into the
carrying frame.
4. Adjust the length of the upper belts as required by
means of the buckles.
*If desired, the carrying belt can be completely
removed from the transmitter.
Transmitter mode
1. When the receiver is ON, unlock the
EMERGENCY OFF button of the transmitter by
turning to the right, and set the selector which to
“ON”.
2. If an engine ON/OFF switch is fitted, start the
truck engine using the selector switch.
3. If no control switch is operated when the
transmitter power supply is switched on, the
transmitter first sends “address telegrams” without
a control command. The LEDs flash “GREEN”.
After 20 seconds the “idle state circuit” switches
the transmitter power supply off. The LED
extinguishes. The receiver remains in the
“READY” state and the LED remains permanently
8
9
14
13
12
10
11
4
3
2
1
8
9
14
13
12
10
11
4
6
4
5
2
1
Home
