Schweitzer Engineering Laboratories SEL-700G Series, Инструкция по эксплуатации

Страница: 31 / 824

xxix
Date Code 20170814 Instruction Manual SEL-700G Relay
Preface
Conventions
Environmental
Conditions and
Voltage Information
The following table lists important environmental and voltage information.
Wire Sizes and
Insulation
Wire sizes for grounding (earthing), current, voltage, and contact connections
are dictated by the terminal blocks and expected load currents. You can use the
following table as a guide in selecting wire sizes.
Instructions for
Cleaning and
Decontamination
Use a mild soap or detergent solution and a damp cloth to carefully clean the
SEL-700G chassis when necessary. Avoid using abrasive materials, polishing
compounds, and harsh chemical solvents (such as xylene or acetone) on any
surface of the relay.
Technical Assistance
Obtain technical assistance from the following address:
Schweitzer Engineering Laboratories, Inc.
2350 NE Hopkins Court
Pullman, WA 99163-5603 U.S.A.
Phone: +1.509.338.3838
Fax: +1.509.332.7990
Internet: selinc.com/support
Email: info@selinc.com
Condition Range/Description
Indoor/outdoor use Indoor
Altitude
a
a
Consult the factory for derating specifications for higher altitude applications.
To 2000 m
Temperature
IEC Performance Rating
(per IEC/EN 60068-2-1
and IEC/EN 60068-2-2)
–40 to +85°C
Relative humidity 5 to 95%
Main supply voltage fluctuations To ±10% of Nominal voltage
Overvoltage Category II
Pollution Degree 2
Atmospheric pressure 80 to 110 kPa
Connection Type
Wire Size
Insulation
Voltage
Minimum Maximum
Grounding (Earthing)
Connection 18 AWG (0.8 mm
2
) 14 AWG (2.1 mm
2
) 300 V min
Current Connection 16 AWG (1.3 mm
2
) 12 AWG (3.3 mm
2
) 300 V min
Potential (Voltage)
Connection 18 AWG (0.8 mm
2
) 14 AWG (2.1 mm
2
) 300 V min
Contact I/O 18 AWG (0.8 mm
2
) 14 AWG (2.1 mm
2
) 300 V min
RTD Connection
a
a
See Table 2.19 for typical maximum RTD lead lengths.
28 AWG (0.081 mm
2
) 12 AWG (3.3 mm
2
) 300 V min
Other Connection 18 AWG (0.8 mm
2
) 14 AWG (2.1 mm
2
) 300 V min
WARNING
Use of this equipment in a manner
other than specified in this manual
can impair operator safety safeguards
provided by this equipment.