Schweitzer Engineering Laboratories SEL-587Z, Инструкция по эксплуатации

Страница: 134 / 276

7.8
SEL-587Z Instruction Manual
Date Code 20020903
ASCII Command Reference
Command Definitions
CSTATUS
Command
Access Levels 1, 2
Display status data in Compressed ASCII format by typing:
CST <CR>
The relay sends:
<STX>”MONTH”,”DAY”,”YEAR”,”HOUR”,”MIN”,”SEC”,”MSEC”,”87A”,”87B”,
“87C”,”IA”,”IB”,”IC”,”MOF”,”+5V_PS”,”+5V_REG”,”-5V_REG”,”+10V_PS”
,”-10V_PS”,“VBAT”,”TEMP”,”RAM”,”ROM”,”CR_RAM”,”EEPROM”,”yyyy” <CR>
xxxx,xxxx,xxxx,xxxx,xxxx,xxxx,xxxx,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,
“xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,”xxxx”,
”yyyy” <CR><ETX>
where:
xxxx are the data values corresponding to the first line labels and
yyyy is the 4-byte hex ASCII representation of the checksum.
DAT (Date)
Access Levels 1, 2
DAT displays the date stored by the internal calendar/clock. If you set the date
format setting DATE_F to MDY, the date displays as month/day/year. If you
set the date format setting DATE_F to YMD, the date displays as year/month/
day.
To set the date, type DATE mm/dd/yyyy <Enter> if the DATE_F setting is
MDY. If you set DATE_F to YMD, enter DATE yyyy/mm/dd <Enter> . The
valid entry for the year is a number between 2000 and 2199. If you enter two
digits for the year, the relay will automatically enter 20 preceding those
numbers. To set the date to June 1, 2002, enter the following:
=> DATE 6/1/02 <Enter>
6/1/02
=>
You can separate the month, day, and year parameters with spaces, commas,
slashes, colons, and semicolons.
EVE (Event)
Access Levels 1, 2
Use the EVE command to view 15-cycle event reports. See Event Reports on
page 9.2 in Section 9: Event Reports and SER for further details on retrieving
event reports.