Page 5
2.
Important Safety Information
Before Installation
1.
We recommend this appliance be installed or repaired by experienced installers.
2.
Please see our website
www.schweigen.com.au
for experienced installers.
3.
It is dangerous to modify any part of this appliance. Modification of any kind, will immediately
void the warranty.
4.
The manufacturer declines all responsibility in case of failure to adopt proper safety measures.
5.
Ensure that the location in which this appliance is installed, has good and permanent ventilation.
6.
Please consult local laws and regulations and install in accordance.
7.
Use an electrical connector with earth that is correct for your location.
8.
Check that the voltage in your area corresponds to the appliance as indicated on the rating label.
9.
This appliance must be connected to an electricity supply with a
ground connection
.
10.
Check that the installation and electrical connections are made by a qualified technician and that the
indicated instructions and local regulations in force are met, using materials that are compliant with
the applicable legislation.
11.
The company will not be responsible for installations executed by non-qualified staff and
installations that fail to heed the applicable legislation on electrical safety (with regard to both
modes and materials).
12.
The electrical technical data can be found inside the rangehood, after removing the grease filters.
13.
The flexible power cable supplied is already connected internally and emerges from the rangehood
near the air outlet tube.
14. Before installing the electrical connections, you should:
–
Verify that the indicated electrical data coincide with the voltage values and frequency
of the electrical circuit in the house where the rangehood is to be installed;
–
Check that the premises has electrical protection against short circuits and electrocution,
pursuant to the applicable legislation;
–
Always switch off the current using the double-pole switch before maintenance and turn
the power on again for normal use only when the operation has been completed.
