USER MANUAL ZHD01
TEMPERATURE SENSOR
ZHD01
MANUFACTURER INFORMATION
Dear Customer,
should you require technical advice and your
retailer could not help please contact our
technical support.
Schwaiger GmbH
Würzburger Straße 17 90579 Langenzenn
Hotline: +49 (0) 9101 702-199
www.schwaiger.de [email protected]
BDA_ZHD01
Business hours:
Monday to Thursday:
08:00 - 17:00
Friday:
08:00 - 14:30
HOME AUTOMATION
Congratulations and thank you for purchasing the Schwaiger ZHD01
product. Below you will find useful operating guidelines.
Display information
Display
LED
Explanation
Room temperature displayed
Rapid green flashing
Red flashing
Flashes
Runs insertions or deletions
Red flashing every
150 seconds
Red flashing every
30 seconds
Insertions or deletions failed
Z-Wave information
General device class
Multi-level sensor
Specific device class
Routing multilevel sensor
Device type
Routing slave
SDK
4.55
NWI
Yes
Explorer frames
Yes
Manufacturer ID
0x0002
Product type ID
0x0003
Product ID
0x8010
Introduction
Schwaiger ZHD01 is a battery-operated temperature sensor. If it is integrated into the wireless
Z-Wave network, the control buttons can be used to control the heating system.
Disposal information
This device contains no batteries. It is an electrical device. It can be disposed of free of charge at
specified disposal sites.
EC Declaration of Conformity
„Hereby Schwaiger GmbH declares that the ZHD01 product is in compliance with the essential requi-
rements and other relevant provisions of Directive 1999/5/EC. “ The Declaration of Conformity can be
found at the following address: http://www.schwaiger.de/downloads
Installation
LED button
INCREASE temperature
Display
(with backlight)
LOWER temperature
1. Remove the back panel by
sliding it downwards.
3. Fasten the back panel to the wall.
2. Replace the batteries.
4. Gently push the Z-Wave RS on the back panel.
Z-Wave command classes
Command Class
Version
Description
BASIC
V1
• Basic SET: Not supported
• Basic GET: Multi-level sensor get
• Basic REPORT: Multi-level sensor report
(1 °C accuracy)
MANUFACTURER_
SPECIFIC
V2
ID from Danfoss and Z-Wave RS
VERSION
V2
Version of command classes, of the Z-Wave Library
and of Z-Wave RS
BATTERY
V1
Battery status
MULTI_CMD
V1
Conserve battery power by transmitting multiple com-
mands in a single package
WAKE_UP
V2
Switch-on intervals of 5 min to 24 h (default: 60
minutes)
PROTECTION
V2
0 = No protection
2 = User interface locked
CONFIGURATION
V2
Specific Z-Wave RS configuration
SENSOR_MULTILEVEL
V6
Specifies the value from the room temperature sensor
again
CENTRAL_SCENE
V1
By pressing the LED button the transmission of
CENTRAL_SCENE_ NOTIFICATION is triggered.
THERMOSTAT_
SETPOINT
V3
When selecting a temperature setpoint on the display
controller, the setpoint is reported.
SCHEDULE
V1
When selecting a temperature and a number of hours
on the display controller reported the program change
values.
INDICATOR
V1
Control of the LED display.
Paste in Z-Wave
• Make sure that Z-Wave RS is in the factory defaults setting.
• Activate „Inclusion/Paste“ on the Z-Wave controller.
• Press the LED button on Z-Wave RS.
• Check the process status on the controller and Z-Wave RS.
