Operating manual GPD 3000
Error message
The GPD 3000 has a sensor control from software version 3.02 and
above. If an error occurs, the display shows “F 30” and the red LED is
on. In that case the device is not ready for operation and can be
switched off. Please check if the sensor is installed in the correct way.
The markers of the sensor (“nose”) and the circuit board (white bar)
have to be at the same place. Please pay attention that the head of the
sensor does not contact the circuit board to prevent a short circuit! So
don't put the sensor too deep into the circuit board.
If the error still occurs the device needs a maintenance by Schütz
GmbH Messtechnik or one of the official service partners.
- 15 –
