Assembly
05.00 | WSG 25 | Assembly and Operating Manual | en | 389684
23
5.2 Mechanical connection
The threads and centering holes which can be used to mount the
product are shown in the following figure.
The product has M3 threads for fixing on the rear of its housing as
well as Ø 4 mm centering holes. Additionally the product can be
mounted at its side by two through-holes. When in holding mode,
the product constantly adjusts the gripping force, to ensure a
constant gripping force. The surfaces which are screwed together
must be capable of dissipating the resulting heat.
NOTICE
Risk of overheating!
•
Please ensure that the thermal coupling is good, especially if
the product is to apply high gripping forces over longer
periods of time.
•
Prevent exposure to external sources of heat, such as from
your robot’s pan-tilt unit, as this can reduce the product’s
performance.
•
Poor dissipation of heat or exposure to additional heat will
require the gripping force to be reduced.
NOTE
To ensure fault-free operation and to minimize the radiation of
electromagnetic interference (EMC) the product’s housing must
be properly earthed.
