SCHUNK VERO-S NSE plus 100-75, Перевод оригинального руководства по эксплуатации

Страница: 48 / 68

Assembly
48 04.00|NSE plus, NSL plus, NSD plus |en
Information to clamping pin SPG 40
The SPG 40 can be used with a clamping position instead of the
SPA 40.
With several clamping positions, all three types of clamping pins
can be replaced with the SPG 40.
The repeat accuracy increases to < 0.002 mm when using the
SPG 40.
When connecting the screws from above, an M12 screw 10 mm
longer of strength class 12.9 must be used after order of prefer-
ence 2.
Options
See also

Pneumatic circuit diagram [

52]
Dynamic pressure monitoring of the clamping slide position for
quick-change pallet modules
For the sizes NSE plus 138, NSE plus 138-V1, NSE plus 176,
NSE plus 176-V1 and NSE plus 100-75 dynamic pressure monitor-
ing of the clamping slide is possible. Pressure build-up in
"OPENED" status. Control of the clamping slide monitor requires a
reduced pressure supply limited to 2 bar (see chapter "Pneumatic
circuit diagram"
(

4.7, Page 52) ).
The measurable differential pressure must reach a minimum of
0.5 bar in order for a reliable evaluation to be done via the air
gap sensor. The maximum pressure is 2 bar. Monitoring requires
a pressure gauge, an adjustable throttle and an air gap sensor.
For monitoring of the clamping slide, the predefined connection
must be accessed via a base side bore hole. For the NSE plus 100-
75, the predefined connection must be accessed via a base side
bore hole.
Request our installation drawings if doing the installation yourself.
4.5.1
4.6
4.6.1