SCHUNK UFG 66, Сборка и руководство по эксплуатации

Страница: 22 / 28

Troubleshooting
22
04.00 | UFG 66 | Assembly and Operating Manual | en | 389470
5 Troubleshooting
5.1 Modul does not move?
Possible cause Corrective action
Hydraulic supply is interrupted preserve hydraulic supply
Component part defective. Send product with a SCHUNK repair order or
dismantle product.
Assembly drawing [ } 24]
hydraulic wirings are interchanged check hydraulic wirings
minimum pressure fell below check hydraulic supply Technical data [ } 14]
unused hydraulic connections are open Close unused hydraulic connections
Proximity switch defective or set incorrect. Readjust or change sensor.
Base jaws jam in housing, e.g. mounting
surface is not sufficiently even. Check the evenness of the mounting surface.
Mechanical connection [
}
15]
Loosen the mounting screws of the product
and actuate the product again.
5.2 The gripping force drops?
Possible cause Corrective action
Dirt deposits between basic jaws and
guidance. Remove the cover, clean the product and
regrease it
Assembly drawing [
}
24]
Pressure drops below minimum. Check the hydraulic supply
Technical data [ } 14]
Mounting surface is not sufficiently flat. Check the evenness of the mounting surface.
Mechanical connection [ } 15]
Component part defective. Send product with a SCHUNK repair order or
dismantle product.
Assembly drawing [ } 24]
Internal leak oil loss Send product with a SCHUNK repair order or
dismantle product.
Assembly drawing
[ } 24]