SCHUNK ROTA-S flex, Сборка и руководство по эксплуатации

Страница: 31 / 40

Maintenance
9.3 At least once a month
Lubricate the chuck at the two lubrication nipples (item 37) on the
circumference of the chuck body (item 1) using a manual press.
Use LINOMAX plus by SCHUNK as lubricant.
The chuck must be in fully the open position (jaw change position)
so that all the important areas are covered with grease by the
lubrication system.
• The functional surfaces of the wedge bars (items 5 and 6) and
the drive ring (item 7) are reached via the lubrication nipple
opposite jaw 1. The second greasing area supplies grease to the
spindle bearings and the spindle thread.
• After lubricating, open and close the chuck 2 – 3 times without
a workpiece to evenly distribute the grease across all the
functional surfaces.
• Clean the guideway extensions and apply LINOMAX with a
brush.
9.4 In the case of decreasing clamping force or after approx. 200
operating hours
If the clamping force decreases, the inside of the chuck is
contaminated or the coolant has washed out or decomposed the
grease.
In this case, disassemble the chuck, carefully clean all parts with
degreasing agent and check for wear and damage.
Replace damaged parts with original SCHUNK spare parts only!
Before installation, lubricate all individual components with
LINOMAX special grease.
This cleaning procedure should be performed about every 200
operating hours, depending on the extent of stress on the chuck.
31 06.00 | ROTA-S flex | Assembly and Operating Manual | en | 0889139