Assembly
26
04.00 | GSM-R | Assembly and Operating Manual | en | 389106
Example:
Product with 7 mm nominal stroke per jaw
7 mm * 20% = 1.4 mm
NOTE
The table of values applies only to sensors whose hysteresis has
been taught. For further information see assembly and operat-
ing manual of the sensor.
5.3.5 Assembly and setup of the MMS-P 22
Position and installation of the magnetic switch MMS-P
1 Sensor MMS-P
(left groove)
Monitoring gripper position 1 and gripper
position 2 in the left rotating angle end
position (signals SGL1 and SGL2)
2 Sensor MMS-P
(right groove)
Monitoring gripper position 1 and gripper
position 2 in the right rotating angle end
position (signals SGR1 and SGR2)
3 Stop for MMS-P Determining the clamping position of the
MMS-P sensor
Monitoring GSM locations/positions/end positions:
SGL1: left rotating angle end position, gripper position 1
SGL2: left rotating angle end position, gripper position 2
SGR1: right rotating angle end position, gripper position 1
SGR2: right rotating angle end position, gripper position 2
By each of the two sensors MMS-P, 2 gripper positions can be mon-
itored. If the gripper is in a third position, the rotation angle end posi-
tion can only be monitored by additional sensors.
