Maintenance
58
25.00 | DPZ-plus | Assembly and Operating Manual | en | 389035
Size 125–200 with
two assembly devices
Fastening elements for assembly device
Item Designation
DPZ-plus
125
160
200
100
Assembly device 1
x
x
x
101
Screw DIN ISO 4762
M8 x 50 M8 x 60 M10 x 70
102
Cylindrical pin
6m6 x 16 6m6 x 16 8m6 x 20
103
Assembly device 2
x
x
x
104
Screw DIN ISO 4762
M8 x 40 M8 x 45 M10 x 50
Ø
Install and grease device 1 (100).
Ø
Insert spring (25) through the centering bore in the housing (1).
NOTE
Do not damage the sealing lips of the seal (30).
Ø
Place the cylinder piston (62) with the seal (30) on the centering
bore and evenly push it into the bore hole by hand so that it
pushes the spring (25). When doing this, pay attention to the
correct installation position.
Ø
For sizes 125–200:
Position device 2 (103) and secure to
device 1 (100).
Ø
Tighten screw (45).
Ø
For sizes 125–200:
Remove devices.
For sizes 40-100:
Remove device 1 (100).
Ø
Insert the cylindrical pins (55) into the housing (1).
Ø
Insert seal (32) / O-rings (32/34) into the cover (9).
Ø
Fasten the cover (9) with the screws (46).
Ø
Insert the flat seal ring (39) into the side cover (12).
