Maintenance
28.00 | DPG-plus | Assembly and Operating Manual | en | 389031
49
Assembling
NOTE
Tighten all screws with the required tightening torque.,
62].
Ø
Insert the base jaw (2/7) into the intermediate jaw (13) and
tighten the screw (43).
Ø
Insert the seal (31) into the housing (1) from above.
Ø
Push the base jaw (2/7) into the housing (1), observing the
correct installation position.
Ø
Insert the piston (3/8) into the housing (1) from above.
Ø
Position the base jaws (2/7) so that the piston (3/8) can be
pushed into the base jaws (2/7) without any problems.
Ø
Previous version:
Slide the cylinder piston (60) from below into
the housing (1), observing the correct installation position.
Ensure that the sealing lips of the seal (30) do not become
damaged while sliding in the cylinder piston.
Successor version:
Slide the cylinder piston (71) into the
housing (1) from below. When doing this, observe the correct
installation position. Ensure that the sealing lips of the seal (30)
do not become damaged while sliding in the cylinder piston.
Ø
Screw in the screw (40).
Ø
Insert seals (34) / (32/38) into the cover (4).
Ø
Fasten the cover (4) with screws (41).
Ø
Previous version:
Insert the gasket (14) into the housing (1).
For DPG-plus 240 / 300: Insert O-ring (39) into the side
cover (12).
Note: The product must be in the "Gripper closed" position to
prevent the gasket (14) / the O-ring (39) from jamming.
Successor version:
Insert the flat seal ring (39) into the side
cover (12).
Ø
Put on the side cover (12), making sure the installation position
is correct.
NOTE
Do not damage the sealing lips of the seal (36) with the
intermediate jaw (13).
