For
24V batteries
the following charging parameters can be selected
via the “Function" button:
4A
For charging 24V 5Ah to 80Ah batteries
Maintenance for 24V 5Ah to 120Ah batteries
Suitable for charging WET and Gel batteries
8A
For charging 24V 50Ah to 160Ah batteries
Maintenance for 24V 50Ah to 250Ah batteries
Suitable for charging WET and Gel batteries
4A
For charging 24V 5Ah to 80Ah batteries
Maintenance for 24V 5Ah to 120Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB batteries
8A
For charging 24V 50Ah to 160Ah batteries
Maintenance for 24V 50Ah to 250Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB batteries
After selecting the appropriate 24volt function the charging process starts automatically after 5 seconds.
Additional battery charger functionallity can be selected using the mode button as follows.
SHOW
ROOM
SHOW ROOM
function: 13.8 V. This function keeps vehicle accessories in operation during
demonstrations in the dealership by supporting the connected vehicle battery. (Only in 12V mode)
SUPPLY
POWER SUPPLY
function: 14.0 V. Press and h
old the “Mode " key for 5 sec to activate this function.
This function allows you to keep the memory of a vehicle active during battery changes or in all cases
where the battery is disconnected from the vehicle circuit. (Only in Mode 12V)
Warning: in this function the charger is not protected against reverse polarization. RISK OF
DAMAGE
!
Charging reports:
Battery charging.
Green LED flashing.
The battery is 100% charged, from this moment the charger enters the maintenance phase and will
constantly monitor the state of charge of the battery, ensuring that it always remains at an optimal level.
Fixed green Led.
INTERRUPTION OF THE CHARGE CYCLE DUE TO LOSS OF AC SUPPLY.
In case of interruptions on the 230V mains line the charger stores the working cycle it was running so
that it
can automatically resume when the power is returned to the 230 Volt MAINS line. This function
is essential in cases where the charger performs charge cycles in the absence of an operator; for
example during very long working cycles (maintenance charges) or night cycles (charges for means
that need daily charge cycles).
END OF CHARGE
1.
Disconnect the power cord of the appliance from the mains socket
2.
Disconnect the output conductor with black clamp from the ground of the vehicle or the negative
terminal (-) of the battery.
3. Disconnect the output conductor with red clamp from the positive terminal (+) of the battery.
