![Schumacher SpeedCharge 1000AP Скачать руководство пользователя страница 11](http://html1.mh-extra.com/html/schumacher/speedcharge-1000ap/speedcharge-1000ap_owners-manual_1215196011.webp)
11
TROUBLESHOOTING
Performance problems often can be corrected by the user. Please completely read
this chart for possible solutions to common problems.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Check RED light Is on.
The battery is not connected
Connect or adjust clips.
correctly.
Check for correct polarity.
The battery is less than one
Replace the battery or try
volt.
using a manual charger to
bring above 1 volt.
Indicator lights are lit in an
A button may have been
Make sure nothing is
erratic manner not explained
pressed when the charger
touching the control panel,
in the “Using Your Battery
was plugged in.
then unplug the unit and
Charger” section.
plug it in again.
The charger may be
Return to place of purchase
defective.
for replacement.
The Check RED light is
Charger in abort mode.
See “Using Your Battery
flashing.
Battery may be bad.
Charger."
The CHECK (red) light
This will happen if the
Reset the charger by un-
always flashes before the
battery did not reach full
plugging it or briefly discon-
battery is completely
charge within 24 hours. May
necting the negative battery
charged.
be due to a very large
clip. Select the desired
battery or a bank of batteries
charge rate and battery type
requiring more power than
again, if necessary.
the charger can deliver in
24 hours. Battery may also
be faulty.
The green CHARGED light
The battery may be fully
If the battery is in a vehicle,
turns on a few minutes after
charged or recently charged,
turn the headlights on for a
connecting to the battery.
leaving the battery voltage
few minutes to reduce the
high enough to appear to be
battery voltage and try
fully charged.
charging again. Also try a
lower CHARGE RATE
selection.
The charger is making an
The charger has a relay that
No problem, this is a normal
audible clicking sound.
turns the current on and off
condition.
to the battery.