2. PERSONAL SAFETY PRECAUTIONS
2.1
Wear complete eye protection and
protective clothing when working near
lead-acid batteries. Always have someone
nearby for help.
2.2
Have plenty of fresh water, soap and
baking soda nearby for use, in case battery
acid contacts your eyes, skin, or clothing.
Wash immediately with soap and water
and seek medical attention.
2.3
If battery acid comes in contact with eyes,
flush eyes immediately for a minimum 10
minutes and get medical attention.
2.4
Neutralize any acid spills thoroughly with
baking soda before attempting to clean up.
2.5
Remove all personal metal items from your
body, such as rings, bracelets, necklaces
and watches. A battery can produce a
short circuit current high enough to weld a
ring to metal, causing a severe burn.
2.6
Never smoke or allow a spark or flame in
the vicinity of the battery or engine.
2.7 WARNING:
This product contains one
or more chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
3. FEATURES
3
5
4
6
7
8
1
2
1.
Worklight ON/OFF switch
2.
Rotary switch for USB and jump starter
3.
Built-in work light
4.
Battery status indicators
5.
Battery status button
6.
USB port
7.
12V DC power outlet
8.
Battery clamps
9.
Air compressor gauge
10.
Air compressor ON/OFF switch
11.
Internal battery charger port
12.
Air compressor hose wrap cleats
13.
Air compressor hose
14.
Air compressor adapters
and storage bag
9
14
13
10
11
12
4. CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER
IMPORTANT:
CHARGE IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE AND
EVERY 30 DAYS, TO KEEP THE UNIT’S
INTERNAL BATTERY FULLY CHARGED
AND PROLONG BATTERY LIFE.
4.1 CHECKING THE LEVEL
OF THE INTERNAL BATTERY
Press the Battery Status button on the
front of the unit. The LED lights will indicate
the current charge level as follows:
RED –
less than 20% of full charge;
immediately charge the unit.
YELLOW/ORANGE –
20-80% of full
charge.
GREEN –
more than 80% of full charge.
4.2 CHARGING THE INTERNAL BATTERY
Charge the unit’s internal battery using an
extension cord (not included).
NOTE:
Use of an improper extension
cord could result in a risk of fire and
electric shock.
3.
To charge, flip the AC connector on
the back of the unit DOWN and plug in
an 18 AWG or larger extension cord.
4.
Plug the extension cord into a 120VAC
electrical wall outlet.
5.
While the jump starter is charging, the
RED LED
will be on. Complete charging
may take up to 72 hours. When the
RED LED
turns off, the jump starter is
ready to use.
