background image

4. FEATURES

1.

Charging status LED indicator

2.

SMD LEDs (30)

3.

Rocker switch:

HIGH (II) / OFF (O) / LOW (I)

4.

Charging input jack

5.

Thumb screws

6.

12V DC car charger

7.

100-240V AC wall charger

1 2

3

4

5

6

7

5. CHARGING

IMPORTANT! CHARGE THE WORK

LIGHT IMMEDIATELY AFTER

PURCHASE, AFTER EACH USE, AND

AT LEAST EVERY 3-6 MONTHS.

Failure to do this will reduce the battery’s

capacity and may void the warranty.

5.1 

Before charging, make sure the rocker 

switch is in the OFF (O) position. Failure 

to do so will damage the charger plug/

vehicle plug.

5.2  Using the AC wall charger: 

Insert the end of the AC charger cable into 

the input jack on the back of the work light. 

Plug the AC charger into a live AC outlet.

5.3  Using the 12V DC car charger: 

Insert the end of the 12V DC car charger 

cable into the input jack on the back of the 

work light. Plug the 12V DC car charger into 

a 12V DC power outlet.

NOTE: Charging the work light from a 

12V vehicle socket will drain the vehicle’s 

battery, unless the engine is running.

5.4 

Plug into your power supply. The charging 

LED will light 

RED

, to indicate charging has 

begun.

5.5 

Charging will take approximately 4-6 hours.

When the battery is fully charged, the 

charging LED will change to 

GREEN

.

5.6 

When fully charged, unplug the charger 

from the AC or DC outlet, and then from

the work light. The work light is now ready 

for use.

5.7 

Recharge the work light after use, and at 

least every 3-6 months.

6. OPERATING INSTRUCTIONS

6.1  IMPORTANT:

 Charge the internal battery

before use. Make sure the rocker switch is 

in the OFF (O) position.

6.2 

Press the rocker switch on the back of the 

unit to turn on the work light to HIGH (II), 

OFF (O) or LOW (I).

6.3 

The position of the main body can altered 

by loosening the thumb screws and moving 

the main body. 

6.4 

ING

7. MAINTENANCE INSTRUCTIONS

7.1 

After use and before performing

maintenance, unplug and disconnect 

the work light.

7.2 

Ensure the work light is unplugged and 

allowed to cool before attempting any 

cleaning.

7.3 

Any servicing should be performed by 

qualified service personnel.

Отзывы: