•
5
•
9.1 Attach the foot:
Remove the charger
from the packing materials
and place upside
down
on a flat surface.
Attach the foot
and secure it with
the two 10-24 x
5/8”
thread cutting
screws provided.
9.2 Assemble the wheels and axle:
Hold the
axle upright on the floor or work surface.
Then, using a hammer, tap one of the axle
caps onto the top end of the axle. Be sure
to tap the axle cap on straight. Slide both
wheels onto the axle with the recessed
hubs facing out as shown. Install the
second axle cap.
1
2
3
4
5
6
1
2
3
4
5
6
9.3 Mount the axle to the charger:
Place
one end of each bracket into the slot on
the bottom of the charger. Place the axle
assembly under each bracket. Attach
the brackets, using the two 10-32 thread
cutting screws provided.
NOTE:
Be careful not to drop the brackets
inside of the charger case.
1
2
3
4
5
6
1
2
3
4
5
6
9.4 Attach the handle:
Turn the charger
right side up onto its foot and wheels.
Align the handle, so the screw holes
are aligned with the screw
holes on each side of
the charger. Attach the
handle, using the
four 8-32 x 1”
pan head
screws
provided.
10. CONTROL PANEL
ON/OFF SWITCH
Use this switch to select between the
Charge/Maintain rate, Boost rate and the
Engine Start mode.
• OFF –
When the switch is in this position
(middle), the charger is turned off.
• BOOST or CHARGE/MAINTAIN –
When the switch is in this position, the
Rate Selection button can be set to either
the Charge/Maintain 6A<>2A or the
Boost 35A setting.
• ENGINE START –
When the switch is in
this position, the Engine Start LED will
illuminate.
RATE SELECTION BUTTON
Use this button to select one of the
following:
• CHARGE/MAINTAIN 6A<>2A –
For
charging small and large batteries. Not
recommended for industrial applications.
• BOOST 35A –
This setting should only
be used to provide a quick boost to a
severely discharged battery, prior to
using the Engine Start function. Do not
use this setting to charge your battery.
• ENGINE START 200A –
Provides 200
amps for cranking an engine with a
weak or run-down battery. Always use in
combination with a battery.
LED INDICATORS
CLAMPS REVERSED (red) LED
flashing:
The connections are reversed.
BOOST/CHARGING (yellow/orange)
LED lit:
The charger is charging the battery.
BOOST/CHARGING (yellow/orange)
LED flashing:
The charger is in abort mode.
CHARGED/MAINTAINING (green)
LED pulsing:
The battery is fully charged
and the charger is in maintain mode.
NOTE:
See
Operating Instructions
for a
complete description of the charger modes.
1
2
3
4
5
6
1
2
3
4
5
6
