Gas Hob Operating Instructions
Page 3 of 11
MODEL
L (mm)
W (mm)
Electrical Connection
The hobs come equipped with a 3 pin plug and
power cable. The plug and power cable comply
with Australian requirements. Please check the
power rating, voltage and frequency indicated on
the data plate (located on the bottom of the hob as
well as on the front cover of this manual).
If the appliance is to be installed above an electric
built-in electric oven, the electrical connection to
the hob and oven must be carries out separately,
both for electrical safety purposes and to make it
easier to remove the oven.
The supply cable must not come into contact with
surfaces higher than 50
°
C.
! The installer must ensure the electrical
connection has been made and is compliant with
AS/NZS 3000 wiring rules.
Before connecting to the power supply, make sure
that:
•
The appliance is earthed and the plug is
compliant with the law.
•
The socket can withstand the maximum
power of the appliance, which is indicated
on the data plate.
•
The voltage is in the range between the
values indicated on the data plate.
•
The socket is compatible with the plug of
the appliance. If the socket is
incompatible with the plug, ask an
authorised technician to replace it. Do not
use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and
replaced by authorised technicians only (see
Assistance).
! The manufacturer declines any liability should
these safety measures not be observed.
Adapting to various types of gas
Warning: Servicing should be carried out only by
authorised personnel. Should the appliance be
pre-set for a different type of gas than that
TGL 641
640
520
TGL 751
680
520
Bench cutout for both models is 555mm x 475mm
The installation cavity should have the dimensions
indicated in the figure.
Fastening hooks are provided, allowing you to
fasten the hob to tops that are between 20 and 40
mm thick. To ensure the hob is securely fastened
to the top, we recommend you use all the hooks
provided.
Hook fastening diagram
Hooking position Hooking position
For top H=20 mm for top H=30 mm
Hooking position
For top H=40 mm
Front
Back
! Use the hooks contained in the “accessory pack”
Where the hob is not installed over a built-in oven,
a wooden panel must be installed as insulation.
This must be placed at a minimum distance of 20
mm from the lower part of the hob.
Ventilation
To ensure adequate ventilation, the back panel of
the cabinet must be removed. It is advisable to
install the oven so that it rests on two strips of
wood, or on a completely flat surface with an
opening of at least 45 x 560 mm (see diagrams).
! The Hob can only be installed above built-in
ovens with a cooling ventilation system.
