SCHOLTES SODV1410F, Инструкция по эксплуатации и правила безопасности

Страница: 16 / 32

(1
amount of detergent needed depends on
the cycle, load size, and soil level of dishes.
Do not fill detergent into the detergent
compartment more than required; otherwise
you can see whitish streaks or bluish layers
on glass and dishes and may cause glass
corrosion. Continued use of too much
detergent may cause machine damage.
Using little detergent can result in
poor cleaning and you can see whitish
streaksin hard water. See the detergent
manufacturer’s instructions for a further
information.
)LOOLQJWKHGHWHUJHQW
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.
'(7(5*(17
8VLQJFRPELQHGGHWHUJHQWV
These products should be used according
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
5LQVHDLGXVDJH
The rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If rinse aid dosage
setting set too low, whitish stains remains
on dishes and dishes do not dry and
washed clean. If rinse aid dosage setting
set too height, you can see bluish layers on
glass and dishes.
)LOOLQJWKHULQVHDLGDQGVHWWLQJ
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX level
and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
,QRUGHUWRFKDQJHWKHULQVHDLGOHYHO
IROORZWKHEHORZVWHSV
• Open the door of the machine.
•
Press the program button and
simultaneously press the on/off
button.
• Keep on pressing both buttons
until “rA” disappears. Rinse aid setting
follows water hardness setting.
• The machine will display the last setting.
• Set the level by touching the programme
button.
• Turn off the machine to save the setting.
• The factory setting is “4”.If the dishes
are
not drying properly or arespotted,
increase the level. If blue stainsform on
your dishes, decrease the level.