SCHOLTES MGN 31 HK, Инструкция по установке и эксплуатации

Страница: 8 / 12

5
Instructions For Installer
Installation
This appliance is not provided with flue gas
discharge. It is recommended that it is installed in
sufficiently aerated places. The quantity of air
which is necessary for combustion must not be
below 2.0 m
3
/h for each kW of installed power.
Positioning (Fig. 2)
The appliance can be fitted into a working area
as illustrated on the corresponding figure. Before
positioning the hob, fit the seal mastic around the
entire periphery of the hole cut in the worktop.
Keep a clearance from the surrounding
boundaries or objects for the gas hob according
to fig. 2 . The appliance should be fixed by
mounting brackets.
If another built-in appliance (e.g. dishwasher,
washer, etc,) is to be installed under the gas hob,
keep a clearance of at least 20mm from the
bottom of the gas hob. If the installation of the
appliance underneath requires a different
distance, adopt the larger value.
Gas connection
Connect the appliance to the gas supply
according to the prescribed standards in force,
and ensure, that the appliance matches with the
type of gas supply. Furthermore, check that the
supply pressure is within 1.5 kPa and governor
pressure is 1.0 kPa.
N.B. – Connecting a flexible stainless steel pipe to
a threaded end
The gas supply pipe connection of the hob is a ½
threaded male end.
The flexible pipe must not be longer than 2000 mm
when fully extended. Once connection has been
carried out, make sure that the flexible metal pipe does
not touch any moving parts and is not compressed.
N.B. – Checking the tightness of the connection
When the installation has been carried out, check the
gas soundness of appliance and piping by equipment.
Never use naked flame.
Electrical connection (Fig. 3)
Prior to carrying out the electrical connection, please
ensure that:

the power supply follow what is indicated on the
badge label placed at the bottom of the base tray;

the appliance is fitted with an efficient earth
connection, following the standards and law
provisions in force. The earth connection is
compulsory in terms of the law.
Under no circumstances should the cable reach a
temperature above 50°C of the ambient temperature.
If connecting directly to the mains power supply, fit a
multi-pole switch of a suitable size for the rated
capacity which completely disconnects the power line
under overload conditions, in conformance with code
(the yellow/green earth wire must not be interrupted).
The plug or switch must be easily reached on the
installed appliance.
If the power cable becomes damaged, it
must only be replaced by a qualified
technician.
ENG