SCHOLTES HL 458, Инструкция по монтажу и эксплуатации

Страница: 30 / 60

30
EN
Control panel
The hood is equipped with a “TOUCH SENSOR”
device able to determine the control of the lights and
the speed when the user touches the control bar. Read
the instructions below carefully for this purpose.
Automatic switch-on function
The hood is equipped with a temperature sensor that
starts the motor at the 1st suction speed (power) when
the room temperature around the hood is higher than
70°C.
The user can, however, switch off or modify the suction
speed (power). (See paragraph “Control of suction
speed (power))”.
Control of suction speed (power)
The selection of the suction speed (power) is cyclical,
according to the speed sequences “”stand-by - 1-2-3-
4- Stand by -1-2-”… so that at every touch of the
UPPER PART of the control bar the suction speed
(power) increases by a level and then to switches off
(stand-by) if the control bar is touched again when the
hood is at suction speed (power) 4.
It is possible lo turn the hood off (standby) even when
the hood is at any speed by pressing the UPPER PART
of the control bar (for more than 3 seconds).
It is possible to determine what suction speed (power)
the hood is in when the bar is equipped with a led that
changes colour on the basis of the suction speed
(power), as follows:
Hood in stand-by: LED OFF
1st suction speed (power) - led GREEN
2st suction speed (power) - led ORANGE (amber)
3st suction speed (power) - led RED
4st suction speed (power) - led RED (FLASHING)
Note: the 4th aspiration speed (power) remains on for 5
minutes after which the aspiration motor positions itself
on the 2nd speed.
Touched once more, the suction motor switches off
(Stand-by).
Need to wash the anti-fat filter: GREEN led FLASHING
(read the instructions relative to “Reset and
configuration of the filters saturation signal")
Need to wash or replace the carbon filters: ORANGE
(amber) led FLASHING (read the instructions relative to
“Reset and configuration of the filters saturation
signal”)
Control of the central light
The central light can be switched on and off by
touching the LOWER PART of the control bar BRIEFLY.
Control of the lateral lights (when envisaged)
The lateral lights can be switched on and off by
touching IN A PROLONGED MANNER the LOWER
PART of the control lever.
The PROLONGED TOUCH allows, other than switching
on and off, adjusting the intensity of the light emitted by
the lamp.
Note: The functions of switching and off (and
adjustment) alternate.
The light intensity regulation feature is not available for
hoods with neon lights.
Reset and configuration of the filters saturation signal
Switch the hood on at any speed (see paragraph
above “Selection of the suction speed (power)”
Description of the appliance