Schoeps DSP-4 KFM 360, Руководство по эксплуатации

Страница: 6 / 20

6
Quick Start
Recording for Post-Production
Simply connect the microphones to a digi-
tal four-channel recording device that offers
48V phantom power and the needed gain.
The signals of the KFM 360's omnis must
be connected to input I and the figure-8s to
input II (see bottom of this column; channel I
= left side = yellow mark on the SCHOEPS
Y-cable). This way each pair will correspond
to one AES/EBU signal.
For post-processing, the two AES/EBU
signals should be connected to the digital
inputs I (omni) and II (figure-8):
You can use the DSP-4 KFM 360 as a
microphone preamplifier and/or A/D
converter
You can use the DSP processor as a
microphone preamplifier together with its
A/D converter.
KFM
360
left,
yellow mark
1 3 2 4
right,
red mark
channels
front
A red dot
indicates
the front of
the figure-8
red mark
Setting up and connecting the KFM 360 and CCM 8Ls
Note:
When the KFM 360 is suspended (e.g. from the ceil-
ing), left and right are reversed.
How to connect the KFM 360 and the CCM 8Ls to the
processor
A red marking
on one screw
indicates the
right side of
the KFM 360
Before powering on the unit for the first
time, please make certain that the volt-
age selector is set correctly for your
area. The voltage selector is on the rear
panel beneath the on/off switch; see
photos and instructions on page 12.
Y-cable
Lemo
XLR-5-
or minia-
ture con-
nector
For alternative hookup
arrangements see
page 13, column 1.