21
MONORAIL BM
No mounting rail is required to run the carriage on and off.
The carriages are pushed onto the rails and form a unit together with the rail. To
maintain the required tolerances, do
not
interchange the carriages of different rails
with each other.
1.
Run off the carriage parallel to the rail. When doing so, ensure that the
carriage does not tip over.
2.
Carefully and without tipping it, run the carriage back onto the relevant rail. To
do this, position the carriage parallel to the rail and move it gently back and
forth.
When doing so, observe the following for carriages with metal wipers ABM:
–
Slightly undo the fastening screws of the metal wiper on the front plate.
–
Run the carriage onto the rail.
–
Ensure that the radial air gap between metal wipers and rail is even and
tighten the fastening screws again.
8.3
Replacing the additional caoutchouc wipers
Additional wipers are wear parts which are replaced when worn.
Ð
Undo the screws on the front plate of the carriage, push off the additional
wiper over the rail and push the new additional wiper back on.
Ð
Undo the screws on the front plate of the carriage, remove the additional
wiper directly from the rail and replace it.
MONORAIL MR
MONORAIL BM
MONORAIL MR
MONORAIL BM