1 Safety
6
SCHMIDT
®
ServoPress 605-660
– V1.1
Further information regarding the safe operation of the press can be found in
the corresponding chapters of this manual.
1.4 Noise emission of the press
WARNING
Different noise emission values
Noise emission values determined according to the EN ISO 16092-1
(Machine tools safety - Presses - Part 1: General safety requirements)
standard, Appendix F, may underestimate the noise emissions of the
machine under real operating conditions.
The noise level value emitted by the press can be found in chapter "6.1
Technical data".
Measures for noise reduction
The stroke speed of the press has a significant influence on the noise level
value. Reducing the speed reduces the noise emission.
For further information, refer to the "Instructions for Use - SCHMIDT Manual
workstation"
respectively
the
"Assembly
Instructions
-
SCHMIDT
Components for automation".
1.5 Standards and regulations
Some important standards and regulations to be observed when operating a
press are listed below.
However, this list serves merely for your information. SCHMIDT Technology
cannot be held liable for the completeness of this list.
Machine directive 2006/42/EC
EN ISO 12100 (Safety of machinery - General principles for design -
Risk assessment and risk reduction)
EN ISO 13854 (Safety of machinery - Minimum gaps to avoid crushing
of parts of the human body)
EN ISO 13857 (Safety of machinery - Safety distances to prevent hazard
zones being reached by upper and lower limbs)
EN ISO 16092-1 (Machine tools safety - Presses - Part 1: General safety
requirements)
EN ISO 16092-2 (Machine tools safety - Presses - Part 2: Safety
requirement for mechanical presses)
