Schmalz VS-W-D-K Series, Инструкция по эксплуатации

Страница: 13 / 16

30.10.06.00060
Status 02.2009
Index 01
Page 13/16

2008 J. Schmalz GmbH
J. Schmalz GmbH
Förder- u. Handhabungstechnik
Aacher Straße 29, D 72293 Glatten
Tel.: +49(0)7443/2403-0
Fax.: +49(0)7443/2403-259 info@schmalz.de
www.schmalz.com
Output type
Hysteresis mode Window comparator mode
Condition: P1(n1) > P2(n2)
P3(n3) > P4(n4)
Output hysteresis value can be pre-set.
Condition: P1(n1) < P2(n2)
P3(n3) < P4(n4)
Within pressure setting range, the pressure sensor output can be ON or OFF.
VS-P10-... at normal open mode VS-V-... at normal open mode VS-P10-... at normal open mode VS-V-... at normal open mode
VS-P10-... at normal close mode VS-V-... at normal close mode VS-P10-... at normal close mode VS-V-... at normal close mode
Additional settings
Zero point Key lock mode

Press the

+
 buttons at the same time until the Display shows „00“.
Release the button to end zero setting.

Use the buttons

or

to select key lock/unlock mode.

The key lock mode can prevent operation mistakes.
The Max. value display mode

Press the

button 2 seconds to enter the max. value mode. The pressure
sensor will detect the max. value and keep display.

Press the

button 2 seconds to return to measure mode.
The min. value display mode

Press the

button 2 seconds to enter he min. value mode. The pressure
sensor will detect the min. value and keep display.

Press the

button 2 seconds to return to measure mode.
Return the switch to factory settings

Press the buttons

+ SET at the same time and then switch-on power
supply. The switch returns to factory settings.
Error code instruction
Error name Error code Error instruction Troubleshooting
Excess load
current error
OUT 1
Excess load current of 80 mA.
Turn power supply off and check the cause of overload
current or lower the current load under 80 mA, then restart.
OUT 2
Residual pressure error
During zero reset, ambient pressure is over +-0.03 MPa for
positive pressure, or over +-3.0 kPa for compound and
vacuum pressure.
Change input pressure to ambient pressure and perform
zero reset again.
Applied pressure error
- - -
The applied pressure is excess the upper limit of pressure
setting.
Adjust the pressure within applied pressure range.
- - - -
The applied pressure is excess the lower limit of pressure
setting.
System error
Internal data error
Turn power off, and then restart. If error condition remains,
please return to factory for inspection.
Internal system error
Internal data error
Internal system error