Schlage LE162, Инструкции по установке и Руководство пользователя

Страница: 24 / 28

TROUBLESHOOTING
(continued)
Problem Lights/
Beeps Cause Solution
at Lock
Cannot change
the
programming
code Red User code already in lock
matches the first four digits of the
programming code you are trying
to add
Select a different programming
code, or delete the user code
that matches the first four digits
you want to use
The first programming code entry
did not match the re-confirmed
programming code entry
Try again. Make sure you enter
the same code twice
Cannot delete
all user codes
at the keypad Red The first programming code entry
did not match the re-confirmed
programming code entry
Try again. Make sure you enter
the same code twice
Lock will not
accept codes
and/or will
unlock itself Fast red
blink. High
and low
alternating
beeps The lock has become de-
synchronised
The lever is depressed
Please turn the key a full
revolution clockwise then anti-
clockwise on the exterior and
interior keyways to reset the
lock.
Release the lever and ensure it at
90 degrees
The key spins
freely and does
not engage the
lock None There is a problem with the
installation, the cylinder driver is
not lined up correctly. Remove the lock from the door
and reinstall, pay close attention
to step 5 of the instructions, the
male and female counterparts of
the cylinder driver must connect.
The key does
not turn or
only turns
slightly and
does not
engage the
lock None There is a problem with the
installation, something is blocking
the cylinder driver from turning.
Usually the lower 54mm hole is off
centre or too small. Remove the lock from the door
and reinstall, pay close attention
to step 1 of the instructions,
ensure the holes are correctly
drilled.
22