Schlage CO-200, Инструкция по эксплуатации

Страница: 4 / 16

4
CO-200 Offl ine Lock User Guide
GETTING STARTED
Follow these steps when setting up a new lock.
1. Install the lock. See the installation guide that came with the lock, or visit
www.schlage.com/support, for more information.
2. Make sure the batteries are installed properly. See Batteries on page 11 for more information.
3. Before programming, the lock may be used in Construction Access Mode. See Construction
Access Mode on page 5 for more information. The lock should remain in Construction Access
Mode until you are ready to set up the rest of the system.
4. Test the lock for proper mechanical and electronic operation. See Testing on page 10 for more
information.
5. When ready to set up for normal use, remove factory default security settings, then program the
user credentials. See Manual Lock Programming on page 6 for more information.
6. Consult the Schlage Utility Software (SUS) User Guide for information about confi guring the lock.
7. Familiarize yourself with the information in this guide.
!
Save this user guide for future reference.
HANDHELD DEVICE (HHD)
!
The Handheld Device is used for programming and setup only.
The Handheld Device (HHD) is used to confi gure locks. The HHD confi gures lock functions that
cannot be confi gured with manual programming, and is used to transfer data fi les between the
access control software and locks.
For more information about the HHD, see the Schlage Utility Software (SUS) User Guide.