Schiller RYAN MATAWAY 744283C, Руководство по установке

Страница: 10 / 42

8
MATAWAY
6. Square the engine with the chassis. If
measurement D(Figure 1) is over 3/4" (19mm)
slide the engine forward as necessary to obtain
proper measurement D. If measurement D is
under 3/4" (19mm) slide the engine rearward
as necessary to obtain proper measurement.
Tighten the engine mounting screws.
7. Align the mounting plate L so that it is
perpendicular to the chassis and the pillow block
bearing is centered on the coupler shaft. Tighten
the two plate mounting screws
H at the bottom of
the plate.
8. Align the pillow block bearing with the coupler
shaft so that there is no vertical or side load on
the shaft and tighten the pillow block mounting
hardware. Torque the pillow block screws to
25 ft.-lbs. (34 N·m).
9. Tighten locking collar K on engine coupler shaft.
Rotate collar counterclockwise on pillow block
shoulder. Using hammer and punch, lock collar
into position. Tighten set screw in collar
K .
10. Engage reel drive clutch. Check the clearance
from the idler pulley M to the belt stop N bolted
to the mounting plate, clearance should be a
minimum of 1/16" (2 mm). If necessary, loosen
the belt stop hardware
O and reposition it.
Tighten hardware.
11. Complete adjustment process by performing
steps 12-17 of the Transmission Belt Adjustment.
TRANSMISSION DRIVE BELT ADJUSTMENT:
12. Perform step one of the Reel Belt adjustment.
13. Slide the transmission assembly forward
until measurement E is less than 3/4" to 2"
(44-50mm).
14. Tighten transmission mounting hardware
securely. Slide chain idler sprocket against the
drive chain until there is 1/8" to 1/4" (3 to 6mm)
play in the chain opposite the sprocket and
secure hardware.
15. Check transmission belt alignment with a
straight edge. Loosen the set screw on the
transmission pulley and slide it in or out to
achieve proper alignment.
16. Check operation of reel and transmission belt
drives. The drive belts should engage without
slipping and disengage so that the unit will not
creep. Readjust if necessary.
17. Reinstall the transmission belt cover. Check
clutch control over-center and belt stop tension
adjustments.
NOTE: Belt cover removed for clarity.
ADJUSTMENTS