Schiller 73-70900, Инструкция по эксплуатации и запасным частям

Страница: 15 / 32

13
CHIPPER/
SHREDDER
ASSEMBLY
Assembly Instructions for: MODEL CS313 CHIPPER / SHREDDER BLOWER
PHOTO 1
PHOTO 2
REFER TO PARTS SECTION FOR
IDENTIFICATION OF PARTS
1. Remove hinge pin (Fig. 4, Item 1) and remove
discharge chute.
2. Remove the end cap from the rotor shaft.
3. Hold blower up to the main frame and secure
with the new hinge pin (Fig. 4, Item 1) supplied
with the blower assembly.
4. Install pulley, bushing and key (Fig. 4, Item 29,
30 & 31) onto the rotor shaft. Do not secure to
shaft at this time.
5. Install belt onto the inside groove on the rotor
shaft pulley, and onto the blower pulley. Idler
should run on the inside of belt for correct
tension. (See Photo 1) Align pulleys to within
1/16". Tighten all pulleys on shafts.
6. Install belt guard support bracket (Fig. 4, Item
33) onto top 1/2" bolt for bearing on main frame
and secure with 1/2" lock nut. (Fig. 4, Item 32)
7. Install belt guard (Fig. 4, Item 27) with (4)
5/16" X 3/4" bolts and washers.
8. Install blower spout (Fig. 4, Item 11) on the
blower tube with (2) 5/16" X 3/4" carriage bolts,
(1) 5/16" locknut and (1) spout knob. Install
blower tube onto blower assembly and secure
with clamp. (See Photo 2)