Schiller 73-70900, Инструкция по эксплуатации и запасным частям

Страница: 13 / 32

11
CHIPPER/
SHREDDER
ASSEMBLY
INSTALLATION INSTRUCTIONS FOR EMERGENCY STOP SWITCH OUTLET ON MODEL 525
Model 525 Tractors:
1. Disconnect the battery ground cable.
2. Mount the electrical outlet on the left side of the
black upper grille panel with two 1/4 x 3/4 flange
bolts and nuts. Choose a location using the existing
slots in the panel.
3. Remove the dash access panel. Starting at the
dash area, route the new harness (the end without
terminals) along the existing wiring harness through
the center pivot area of the tractor. Continue routing
until the wires reach the electrical outlet.
4. Connect the new harness (Part No. 30—187) to the
electrical outlet following the wiring diagram on this
page. Connect the blue wire to the “W” terminal, the
green wire to the “G” terminal and the black wire to
the “BK” terminal.
5. Locate the clutch relay and circiut breakers in the
dash area. Near the breakers find the harness with
two blue wires that comes from the seat switch.
Disconnect the bullet connector on the blue seat
switch wire and connect the female bullet connector
of the 5 inch brown wire to the male bullet connector
on the blue seat switch wire. Connect the male
bullet of the new green wire to the female bullet
connector of the blue wire that goes to the front lift
limit switch.
6. Route the blue wire from the new harness to the
Diagram No. 2 for Model 525 Tractors w/o 2 Second Delay
(before serial no. 1197)
PTO switch. Find the PTO switch terminal with the
blue wire attached. Remove the wire and place the
double male spade adapter on the switch. Replace
the wire and connect the new blue wire to the other
terminal of the double spade.
7. Check the wiring diagram and snap the 5 inch brown
seat switch wire in the relay bulk connector aligned
with 87A on the relay. The green wire from the new
harness aligns with 30. The black wire aligns with 85
and the 10 inch black wire with ring terminal with 86.
Snap these in place and push the connector on the
safety relay.
8. Mount the safety relay on the left side of mounting
panel using the clutch relay mounting screw.
9. Connect the black wire ring terminal to a suitable
ground. Tie all wires to keep them from contact with
moving parts or exhaust system.
10. Reconnect the battery cable, plug in the chipper/
shredder cable and test the emergency stop switch
for proper operation. Pull the switch out for normal
operation. Start engine and engage the PTO. Push
in for emergency stop.
11. Replace all shields.
12. Proper operation will disengage the electric PTO
clutch when the emergency stop switch is pushed
“IN”. To restart, pull emergency knob “OUT” and
engage PTO in the normal manner.