7
Apply one thin layer of BIOPLAST
®
insula-
ting agent only to those parts of the work-
ing model which will be covered by the
mouthguard. Embed model in pellets with
the clear V-shaped part of the BIOPLAST
®
XTREME covering the desired extension of
the anterieur section (eg. from 3-3). Place
pellet cover on pellets. Make sure the plate
is fixed with the soft side down and the
labels being placed in the direction of the
heater. The imprint on the label has to be
readable. Heat the plate by setting the code
or recommended heating times according
to the instructions. Lock pressure chamber
and open after cooling phase has finished.
BIOPLAST
®
XTREME
Instruction manual
GB
1
