Scheu Products Company SPC-54PHB, Руководство пользователя, Страница: 7 / 16

Page -7-
ASSEMBLY INSTRUCTIONS
Figure 8
Step 5
Attach Pole to Pole Support (Figure 7 & 8). Place
Pole into the Pole Support center connector. Then
tighten (6) Set Screws with Hex Allen wrench supplied
with heater.
Figure 9
Figure 10
Step 6
Put LP Cylinder Cover on Base Assembly
(Figure 9). Slide LP Cylinder Cover over Pole and
Pole Support. Be sure that the LP Cylinder Cover
rests level on the base.
Step 7
Attach Manifold to Burner & Control Assembly
(Figure 10). The connection between the fuel line to the
burner is a quick connect connection type. Follow these
steps to assemble:
1. Pull the manifold out of the top end of the pole.
2. Slide/move the quick connect collar of the manifold to
the back.
3. Attach the manifold to the burner and control assembly
by pushing the burner and control assembly connection
all the way through the manifold.
4. Make sure the manifold and burner assembly snap in
properly.
5. Release the quick connect collar of the manifold that
was slid to the back in step (2).
6. Place the burner and control assembly onto the pole.
Models
SPC-54PHW SPC-54PHB SPC-54PHT SPC-55PHS
NOTE: (6) set screws are threaded inside post support.
Figure 7