www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
20 | GB
The equipment and its accessories are made of vari-
ous types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste electri-
cal and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing to
the effective use of natural resources. You can obtain
information on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
12. Troubleshooting
Fault
Possible cause
Remedy
The compressor does
not start.
No supply voltage.
Check the supply voltage, the power plug and
the socket-outlet.
Insufficient supply voltage.
Make sure that the extension cable is not too
long. Use an extension cable with large enough
wires.
Outside temperature is too low.
Never operate with an outside temperature of
below +5° C.
Motor is overheated.
Allow the motor to cool down. If necessary, rem-
edy the cause of the overheating.
The compressor starts
but there is no pres-
sure.
The non-return valve leaks.
Have a service center replace the non-return
valve.
The seals are damaged.
Check the seals and have any damaged seals
replaced by a service center.
The drain plug for condensation water (8)
leaks.
Tighten the screw by hand. Check the seal on
the screw and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
The hose connections have a leak.
Check the compressed air hose and tools and
replace if necessary.
A quick-lock coupling has a leak.
Check the quick-lock coupling and replace if
necessary.
Insufficient pressure set on the pressure
regulator (3).
Increase the set pressure with the pressure
regulator.
10.5 Releasing excess pressure
Release the excess pressure by switching off the
compressor and using the compressed air which is
still left in the pressure vessel, e.g. with a compressed
air tool running in idle mode or with a blow-out pistol.
10.6 Spare-part ordering
Please quote the following in your order for spare
parts:
• Type of device
• Article No. of device
• Ident. No. of device
• Spare Part No. of the required spare part
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Cylinder, piston, piston rings
* Not necessarily included in the scope of delivery!
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
