Scheppach BC52PB, Перевод с оригинального руководства пользователя

Страница: 30 / 68

30 GB
red hot water boiler, a gas-fi red dryer, etc.
Putting the equipment back into operation
1
Remove the spark plug (see section 10 Change and
clean the spark plug).
2
Quickly tug on the starter cord to remove excess oil
from the combustion chamber.
3
Clean the spark plug and check that the electrode gap
is correct, or insert a new spark plug with the correct
electrode gap.
4
Prepare the equipment for operation.
5
Fill the tank with the relevant mixture of fuel and oil.
See the section „Fuel and oil“.
Transport
To transport the machine, empty the petrol tank as
described in section 8 draining fuel. Clean coarse dirt off
the equipment with a brush or hand brush.
12. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.
13. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault Possible cause Remedy
The equipment does
not start
• Correct starting procedure not followed
• Sooted or damp spark plug
• Incorrect carburetor setting
• Blade or nylon cutter mounted incorrectly
• No fuel in the tank
• Follow the instructions for starting
• Clean the spark plug or replace it with a new one
• Contact an authorized customer service outlet
• Reassemble the blade or nylon cutter
• Check the fuel level
The equipment starts
but does not develop its
full power
• Incorrect choke lever setting
• Soiled air fi lter
• Incorrect carburetor setting
• Cutting blade blunt
• Set the choke lever on the position
• Clean the air fi lter
• Contact an authorized customer service outlet
• Have cutting blade resharpened /replaced
The engine does not
run smoothly
• Incorrect electrode gap on the spark plug
• Incorrect carburetor setting
• Clean the spark plug and adjust the electrode
gap, or fi t a new spark plug
• Contact an authorized customer service outlet
Engine smokes
excessively
• Incorrect fuel mix
• Incorrect carburetor setting
• Use the correct fuel mix (see fuel mixing table)
• Contact an authorized customer service outlet
If the temperature of
machines is too high
• Engine is overloaded • Insure the machines have rest at regular time